To be on-stream: a rehabilitation programme for lifting equipment

Lifting equipment often operates in not pleasant conditions and on the edge of its technical capabilities. Complex unprepared sites, tight deadlines of facility commissioning, and as a result - a busy equipment schedule. It goes without saying that sooner or later the equipment fails to function properly, various failures and damages appear.

VERTEX Service Team “Quick and Quality” works for you just for such cases. Our team performs not only diagnostics, maintenance, warranty and post-warranty repair or current service assistance of lifts, but also deals with complex cases. The last of these - is the repair of a self-propelled articulated lift JLG 600 AJ.

The JLG 600 AJ arrived to us with significant damage: the inner section of the main boom was destroyed. This situation has appeared due to the working basket overload, as a result of which there was appeared a crack at the inner section of the main boom where the pin of the cylinder is located, thus further operation of the lift led to its malfunction.

VERTEX Service department performed the following works:

• diagnostics and replacement of the inner boom section,
• rods replacement of the JIB,
• lower boom brackets replacement,
• slip guidings replacement,
• the main boom cable channel repair.

Based on all these manipulations, the JLG 600 AJ was successfully restored and now has returned on-stream. If you need repair or diagnostics of lifting equipment, then service specialists from VERTEX are always ready to assist you!